1. Tanning lotion and sprays clog the filter system<\/h2>\n![\"Pool](\"https:\/\/poolscouts.com\/mckinney\/wp-content\/uploads\/sites\/16\/2021\/12\/Pool-techs-cleaning-a-pool-filter_150-1.jpg\")
<\/h2>\n
<\/h2>\n<\/p>\n
Almost every commercial aquatic facility has a sign \u201cShower before entering the water.\u201d This is to help limit the amount of oil introduce to the swimming pool.\u00a0 Oil and water don\u2019t mix.\u00a0 A solution to help in breaking down the oils in the pool is the regular use of Enzymes.\u00a0 This will help prolong the filter life as well.<\/p>\n
<\/p>\n
2. Heaters need protection<\/h2>\n![\"Pool](\"https:\/\/poolscouts.com\/mckinney\/wp-content\/uploads\/sites\/16\/2021\/12\/Pool-Heater-in-Texas_150.jpg\")
<\/h2>\n
<\/h2>\n<\/p>\n
Many pools in Texas are equipped with either Gas heaters or Heat Pumps for the cooler months. Either system needs to be protected from metal staining that can occur as water circulates thru the internal heater components.\u00a0 A metal sequestrant can be used weekly to prevent and metals from staining your pool surface.<\/p>\n
<\/p>\n
3. There is more to water chemistry than Chlorine and pH<\/h2>\n![\"Calcium](\"https:\/\/poolscouts.com\/mckinney\/wp-content\/uploads\/sites\/16\/2021\/12\/Calcium-Hardness-Buildup-Near-Pool_150.jpg\")
<\/h2>\n
<\/h2>\n<\/p>\n
Calcium Hardness is a key measurable component in a well balanced pool. The performance of calcium can fluctuate greatly with warmer\/cooler water swings and pH.\u00a0 Scaling can occur when Calcium Hardness is too high.\u00a0 This could result in cloudy water, rough surfaces, and heater inefficiency.\u00a0 Corrosive water can occur with Calcium Harness in too low.\u00a0 You may notice etching of plaster, grout dissolving or pitting of concrete surfaces.<\/p>\n
<\/p>\n
4. Test your source water<\/h2>\n![\"Pool](\"https:\/\/poolscouts.com\/mckinney\/wp-content\/uploads\/sites\/16\/2021\/12\/Pool-Scouts-tech-testing-source-water-in-Texas_150-1.jpg\")
<\/h2>\n
<\/h2>\n<\/p>\n
With the high temperatures in Texas and sometimes cooler nights, your pool is more likely to evaporate at a fast rate. Be prepared to know the quality of the water that you refill the pool with.\u00a0 Knowing the new chemistry that you’re adding to the pool may save you on balancing chemicals.\u00a0 If adding water from the tap has a lower pH than the pool’s water, then you can reduce the amount of pH minus you would use to ensure a balanced pool.<\/p>\n
5. Prepare for cooler weather![\"Couple](\"https:\/\/poolscouts.com\/mckinney\/wp-content\/uploads\/sites\/16\/2023\/09\/Let-Pool-Scouts-prepare-your-pool-for-colder-weather.jpg\")
<\/h2>\n
<\/p>\n
Towards the end of the year, it is important to maintain proper filtration time and Chlorine levels. Most of the pools in Texas will stay warm enough to promote algae growth.\u00a0 If your pool has a chlorine feeder or salt system, Chlorine is only produced when the pump is running.\u00a0 Be sure to adjust your time clocks and automation to the proper run time for sanitizing.<\/p>\n
<\/p>\n
<\/p>\n