![\"Pool](\"https:\/\/poolscouts.com\/naplesnorth\/wp-content\/uploads\/sites\/18\/2021\/12\/Pool-Filter-System-in-Florida.png\")
<\/p>\nAs a Naples pool owner,\u00a0 you know the challenges that come with pool ownership. The year-round higher temperatures, with high precipitation levels can result in chemical imbalances that can lead to larger issues with your pool. Here are the top 5 things to know being a pool owner in Naples, so that you’re prepared for different situations that may come up.<\/p>\n
<\/p>\n
<\/p>\n
<\/p>\n
Almost every commercial aquatic facility has a sign \u201cShower before entering the water.\u201d This is to help limit the amount of oil introduced to the swimming pool.\u00a0 Oil and water don\u2019t mix.\u00a0 A solution to help in breaking down the oils in the pool is the regular use of enzymes.\u00a0 This will help prolong the filter life as well.<\/p>\n
<\/p>\n
![\"Pool](\"https:\/\/poolscouts.com\/naplesnorth\/wp-content\/uploads\/sites\/18\/2021\/12\/Florida-pool-technician-skimming-a-pool.png\")
2. Heaters need protection<\/h2>\nMany pools in Florida are equipped with gas heaters or heat pumps for when the weather cools off a bit. Either system needs to be protected from metal staining that can occur as water circulates through the internal heater components. A metal sequestrant can be used weekly to prevent metals from staining your pool surface.<\/p>\n
<\/p>\n
![\"Corrosion](\"https:\/\/poolscouts.com\/naplesnorth\/wp-content\/uploads\/sites\/18\/2021\/12\/Calcium-corrosion-in-a-pool.png\")
<\/p>\n
Calcium hardness is a key measurable component in a well-balanced pool. The performance of calcium can fluctuate greatly with warmer\/cooler water swings and pH.\u00a0 Scaling can occur when calcium hardness is too high.\u00a0 This could result in cloudy water, rough surfaces, and heater inefficiency.\u00a0 Corrosive water can occur when calcium hardness is too low.\u00a0 You may notice etching of plaster, grout dissolving or pitting of concrete surfaces.<\/p>\n
<\/p>\n
![\"Pool](\"https:\/\/poolscouts.com\/naplesnorth\/wp-content\/uploads\/sites\/18\/2021\/12\/Pool-Scouts-beach-ball-in-a-pool-1.png\")
4. Test your source water<\/h2>\nWith the high temperatures in Florida and sometimes cooler nights, your pool water is more likely to evaporate at a fast rate.\u00a0 Be prepared to know the quality of the water that you refill the pool with.\u00a0 Knowing the new chemistry that you’re adding to the pool may save you on balancing chemicals.\u00a0 If the water you add from the tap has a lower pH than the pool’s water, then you can reduce the amount of pH minus you would use to ensure a balanced pool.<\/p>\n
<\/p>\n
![\"Pool](\"https:\/\/poolscouts.com\/naplesnorth\/wp-content\/uploads\/sites\/18\/2021\/12\/Pool-technician-testing-the-water.png\")
<\/p>\n
<\/p>\n
Towards the end of the year, it is important to maintain proper filtration time and chlorine levels. Most of the pools in Florida will stay warm enough to promote algae growth.\u00a0 If your pool has a chlorine feeder or salt system, Chlorine is only produced when the pump is running.\u00a0 Be sure to adjust your timeclocks and automation to the proper run time for sanitizing.<\/p>\n
<\/p>\n
<\/p>\n