![\"Pool](\"https:\/\/poolscouts.com\/sarasota\/wp-content\/uploads\/sites\/9\/2021\/12\/Pool-Filter-System-in-Florida.png\")
<\/p>\nPool owners in Sarasota know that pool service is time-consuming, especially in Florida where the maintenance and upkeep is year-round. The hot weather and varying cooler temperatures in the evening, combined with fluctuating precipitation levels can result in chemical imbalances, leaving you with a messy pool. Here are the top 5 things to know as a pool owner in Sarasota, so that you’re prepared for different situations that may arise.<\/p>\n
<\/p>\n
<\/p>\n
Almost every commercial aquatic facility has a sign \u201cShower before entering the water.\u201d This is to help limit the amount of oil introduced to the swimming pool.\u00a0 Oil and water don\u2019t mix.\u00a0 A solution to help in breaking down the oils in the pool is the regular use of enzymes.\u00a0 This will help prolong the filter life as well.<\/p>\n
<\/p>\n
![\"Pool](\"https:\/\/poolscouts.com\/sarasota\/wp-content\/uploads\/sites\/9\/2021\/12\/Florida-pool-technician-skimming-a-pool.png\")
2. Heaters need protection<\/h2>\nMany pools in Florida are equipped with gas heaters or heat pumps for when the weather cools off a bit. Either system needs to be protected from metal staining that can occur as water circulates through the internal heater components. A metal sequestrant can be used weekly to prevent metals from staining your pool surface.<\/p>\n
<\/p>\n
![\"Corrosion](\"https:\/\/poolscouts.com\/sarasota\/wp-content\/uploads\/sites\/9\/2021\/12\/Pool-Scouts-beach-ball-in-a-pool.png\")
<\/p>\n
Calcium hardness is a key measurable component in a well-balanced pool. The performance of calcium can fluctuate greatly with warmer\/cooler water swings and pH.\u00a0 Scaling can occur when calcium hardness is too high. This can result in cloudy water, rough surfaces, and heater inefficiency. Corrosive water can occur when calcium hardness is too low. You may notice etching of plaster, grout dissolving or pitting of concrete surfaces.<\/p>\n
<\/p>\n
![\"Pool](\"https:\/\/poolscouts.com\/sarasota\/wp-content\/uploads\/sites\/9\/2021\/12\/Pool-technician-testing-the-water.png\")
4. Test your source water<\/h2>\nWith the high temperatures in Florida and sometimes cooler nights, your pool water is more likely to evaporate at a fast rate. Be prepared to know the quality of the water that you refill the pool with. Knowing the new chemistry that you’re adding to the pool may save you on balancing chemicals and other extra pool service. If the water you add from the tap has a lower pH than the pool’s water, then you can reduce the amount of pH minus you would use to ensure a balanced pool.<\/p>\n
<\/p>\n
![\"Pool](\"https:\/\/poolscouts.com\/firstcoast\/wp-content\/uploads\/sites\/24\/2019\/11\/Pool-technician-testing-the-water.png\")
<\/p>\n
<\/p>\n
Towards the end of the year, it is important to maintain proper filtration time and chlorine levels. Most of the pools in Florida will stay warm enough to promote algae growth. If your pool has a chlorine feeder or salt system, chlorine is only produced when the pump is running. Be sure to adjust your time clocks and automation to the proper run time for sanitizing.<\/p>\n
<\/p>\n
<\/p>\n